Something else is wrong there as in correct parallel lens board case the shutter trigger shoul dnot be that far from the shutter lever of the camera body.
Are you sure that you've installed it back correctly? Could it be that the whole lens assy is shifted further from the camera body compared to where it was/where it should be?
Quick check: Focus on something with the RF closeby like at 1m, and check if it matches what the distance scale tells you. Then also check at infinity (a very distant object is good enough).
If you see a mismatch like e.g. at 1m rangefinder focused, the lens focus scale indicates visibly shorter than 1m (say 0.9), means the lens board is too far out.
If they match, then somehow your camera shutter lever got bent.